Doug Fleenor Design Edison Arrayable 25 Lamp Panel Lighting Fixture

Doug Fleenor Design Edison Arrayable 25 Lamp Panel Lighting Fixture

Edison is a 25 lamp fixture with 25 built-in dimmers. Lamps are spaced on six inch centers, three inches in from each edge. The 30 inch square fixture is 1 3/4 inches deep and weighs 24 pounds (without lamps). Edison is arrayable to form large, low-resolution video walls. Steel straps running down the back sides support fixtures hanging below. The front panel is solid 1/10" aluminum, free of visible hardware, and can be powder coated in a variety of colors (stock is silver).

Technical Specifications

DMX input circuit
Protected EIA-485 receiver (LT1785).
Input protection
Undamaged by up to 60 Volts continuous, 15KV transients.
Input signal
0.2 volts minimum, 12 volts maximum, DMX512, DMX512/1990, or DMX512-A.
DMX input connector
Gold plated 5 pin male XLR (Neutrik D-1 series) 3 pin XLR optional.
Input pass through
Gold plated 5 pin female XLR (Neutrik D-1 series). All 5 pins are fed through.
Termination
None. Unused pass through connectors must be externally terminated.
Power input
120 VAC 60 Hz 20 Amps at full load. Actual current draw is 0.05A plus lamp load.
Power input connector
Neutrik 20 Amp PowerCON chassis connector: NAC3MPA.
Mating cable connector
NAC3FCA
Power pass through
Neutrik 20 Amp PowerCON chassis connector: NAC3MPB,
Mating cable connector
NAC3FCB
Idle power
Less than 1 W att.
Power output
120 VAC 60 Hz 0.8 Amps (96W ) maximum per output.
Output protection
Outputs are designed to handle up to 600W overload without damage.
Size and weight
30" square x 1.75" deep, 24 pounds (without lamps).